|
|
 |
|
|
RJ-45
Modular Cable
CAT'5
Patch Cord w/Boots
|
10
base-T / 100 Base-T
RAYTEC's
Category 5 Patch Cord meet new tighter manufacturing
tolerances and more rigid material controls for TSB-40A.
Category
5 10 Base-T patch cords are built to meet 100 MHz
performance. Both models of molded boots and assembly
boots are available. All cables are CSA approved and
fully tested.
Our
Patch Cords Exceed the EIA/TIA 568a Specification:
- Contact:
50µ" gold plating
- Wire:
24AWG, stranded, category 5.
- Meets
or exceeds EIA/TIA 568a specifications.
- Molded
or assembly strain relief available.
- Available
in 3', 6', 10', 15', 25', 50', 75', and 100' length.
- Available
color: black, blue, beige, white, yellow, gray,
red, orange, green.
UTP
Color Coding of Wire Pairs:
- Blue,
Blue-White
- White-Orange,
Orange
- White-Green,
Green
- White-Brown,
Brown
Shielded
Twisted Pair (STP)
Premise
data cable applies for all types of data transmission
applications, primarily for RF or EMI, the RJ-45
modular plug with full metal shell.
Unshielded
Twisted Pair (UTP)
The
predominated media choice for computer and LAN communications,
the RJ-45 modular plug without metal shell.
Common Wiring Configurations
T568A
and T568B wiring scheme are nearly identical
except that pairs two and three are reversed. T568A
is the preferred scheme because it is compatible
with 1 or 2 -pair USOC system. Either configuration
can be used for Integrated services Digital Network
(ISDN) application.
|
|
10-BASE5
Ethernet Cable
10-BASE2
Ethernet Cable
|
The
IEEE 802.3 standard for the operation of 10 Mbps networks.
There are different versions of 802.3, depending on
the type of cabling used, the IEEE standard for thick
Etherent is 10Base5, for thin Ethernet is 10Base2.
10-BASE5
Standard thick Ethernet is called thick because of
the thick coaxial cabling (trunk cable) used in its
application, 10 is for 10 Megabits per second (Mbps)
operation, BASE is for baseband operation, and 5 is
for maximum of 500 meters of cable segment length.
10-BASE2
Thin Ethernet got its name because the coaxial
cable it runs on is thinner than the cable used for
thick Ethernet. 10 is for 10 Mbps operation, BASE
is for baseband operation and 2 is for a maximum of
200 meters of cable segment length.
|
|
|
Token-ring
is an industry standard to connect mainframes and
minicomputers all on one network, it's an open system
allowing different vendor's software & hardware
components full compatibility based on the IEEE 802.5,
Token-ring protocol standard.These multi-purpose cables
can be used as patch cables in wiring closets or TYPE
6 cables with a data connector on each end or DB9
male and RJ-45 plug as shown.
And
Type 1 for the connection between the distribution
cabinet and the wall outlets.
| CM-2431-06 |
DB9
MALE / 4P DATA CONNECTOR TYPE 6 |
| CM-2441-06 |
4P
DATA CONNECTOR EXTENSIONCABLES |
|
 |
V.35
interface cables are used on DTE or DCE equipment
interfacing to a high-speed digital carrier. Typical
assemblies are low capacitance shielded cable with
34-pin connectors. However 25-pin, 50-pin, 44-pin
and 15-pin connector are also frequently utilized.
| CM-2401-06 |
V.35
MALE / D-SUB 25 MALE 6FT |
| CM-2411-06 |
V.35
MALE / V.35 MALE 6FT |
| CM-2412-06 |
V.35
MALE / V.35 FEMALE 6FT |
|
| |
|
| |
|
|
|
|
|
